1. Everyone first open the outer cover of the money detector. This is the interface. It can be opened with soft force without fear of damage.
2. Remove the dust on the drive (too much dust on the drive will slow down the rate of money passing). Here is a little trick for everyone. After connecting to the switch power supply and turning it on, put your finger in front of the human body induction light, and the driver wheel will rotate continuously, and use the rotating friction to easily remove the dust on the driver.
3. Clear the counterfeit infrared tape machine. This place must be cleaned carefully! To avoid dust confuse the infrared eye and cause inaccurate banknote detection.
4. Clear the money release board. Since the first touch of the banknotes is the dust at the banknote opening, there is a lot of dust, so pay attention to removing them. (There is no need to unscrew the screw thread for the money release board of some money detectors, and it can be pulled out immediately.) After cleaning, the money detector is ready to be assembled!