How to use the currency detector
More and more companies choose to purchase the office supplies and equipment they need on the Internet. Companies with large cash flow cannot do without money detector equipment. Many people may come into contact with the currency detector for the first time at this time. So, how do you use the currency detector? Let’s take a look.
1. How to use the currency detector
First turn on the power switch, when only counting the number of sheets without authenticating, press the function key to select the "counting" working mode. Then twist a stack of banknotes into a certain slope and place them flat on the slippery board. The machine will automatically complete the counting work. When all the banknotes on the slippery board have been transported, the machine will stop counting. At this time, the number displayed on the display is the same. The number of stacks of banknotes, take out the banknotes from the banknote holder, and the automatic control of the value displayed on the display when the banknotes are counted will be reset and counted again.
When counting the banknotes, it is best to separate the banknotes according to different denominations and remove the paper subsidies and pollutants on the banknotes. Then fan the banknotes into a small slope. The bundles of banknotes should be slapped and then spread out and placed vertically. Slip wheel.
When the banknotes are incorrectly placed, there will be a false positive for real banknotes or the machine will prompt that the banknotes are not counted correctly. Please reposition the banknotes on the banknote receiver, put them on the banknote input table, and press the reset button to count again. The correct placement of banknotes makes the discrimination ability stronger, and the counting or counting of numbers is more accurate.
When using general money counters, avoid electrical appliances that may cause strong interference to the power grid, such as mobile phones, electric welders, etc., and avoid strong direct light and strong magnetic field interference to avoid false authentication failure.
Twisting the banknote wheel, the runner and the resistance rubber should not be contaminated with grease, otherwise it will cause slippage and result in inaccurate counting.
Wait for no less than 5 seconds after the power is cut off and then turn it on again, otherwise it may cause the machine to work abnormally.
The dust on the counter tube and each sensor should be cleaned thoroughly once a week. Just lift the upper cover up and use a brush to clean the dust. Pay attention to turn off the power before cleaning.
When the money feeding is not smooth or the counting is not correct, you can adjust the gap between the resistance rubber sheet and the money-twisting wheel by adjusting the money-feeding table screw, and then grab a banknote with your hand and put it between the money-twisting banknote and the resistance rubber sheet. Feel the tension. Note: tighten clockwise and relax counter-clockwise.