The most important point in maintaining the banknote binding machine is dust removal. In humid areas, if the dust accumulates more, it will have a great impact on the strong electric parts of the machine. In dry areas, dust contains a large amount of free charge, and the banknote binding machine will also generate some free charge during the process of bundling banknotes. This will cause free charge to accumulate on the banknotes and eventually produce sharp discharges, that is, "static electricity." The phenomenon of electrostatic discharge will have an impact on the machine, ranging from an impact on counterfeiting, and at worst, causing irreparable damage to the integrated circuit of the machine. Regardless of these adverse effects on the machine, too much dust is harmful to the human body. Therefore, the most important task of maintaining the machine is to remove dust.
The place where dust accumulates in the machine is the ultraviolet lamp. The ultraviolet lamp tube is the light source that the banknote binding machine uses optical technology to identify forgery. When it is blocked, the intensity of the light source will decrease, so the sensitivity of forgery will also decrease. In most cases, the optical sensor is very close to the light source. If the lamp tube has a lot of dust, it will also cover the sensor, so that the sensitivity of forgery is lower. The dust here can be cleaned up with a brush or a rag, but you must remember to unplug the power cord of the machine first to avoid electric shock! After removing the dust on the lamp tube, clean the dust box of the machine. For the banknote binding machine with a dust collector, the dust absorbed by the dust collector is contained in a dust storage box, which can be removed for cleaning. The mechanism of the banknote binding machine is very complicated. Do not touch the places that cannot be touched with a brush or a rag, otherwise the machine will be easily damaged.
The wearing parts of the banknote binding machine mainly include rubber parts and purple light tubes. The banknote binding machine is a machine that imitates human money counting. It mainly imitates friction, so it uses some rubber devices. After the rubber device is used for a period of time, the friction force will decrease due to wear, which will cause the performance of the machine to also decrease. In this case, it is necessary to replace the corresponding rubber device. In addition, after the UV lamp has been working for a period of time, the emission ability of the ultraviolet light will also decrease, which leads to the decline of the machine's anti-counterfeiting ability, so the ultraviolet lamp needs to be replaced. The method of replacing them is generally very easy, as long as the corresponding part is removed according to the method required by the instruction manual, and then the new device is installed.