Twisting Part Of The Money Counter

It is mainly composed of a banknote sliding plate, a banknote feeding tongue, a resistance rubber, a banknote dropping plate, an adjusting screw, and a banknote twisting rubber ring. Twisting out the banknotes to be counted one by one is a prerequisite for ensuring accurate counting. The machine uses face-to-face banknotes for continuous grading: the banknote twisting rubber ring twists a banknote on the surface, and the banknote underneath is glued by a resistance rubber to separate the banknotes on the surface from the banknotes below to achieve splitting. This process is repeated until the last banknote is twisted. Due to the trouble of replacement, the abrasion of the money-twisting rubber ring and the resistance rubber has always been two major problems that plague people. To solve this problem, nothing more than: 1. Improve the service life; 2. Easy to replace. For the banknote twisting rubber ring, we can increase the outer diameter and open a groove in the middle of the outer circle to improve the wear resistance of the banknote twisting rubber ring. The contact surface of the apron tooth surface relative to the banknote is enlarged, which improves the adhesion of the apron tooth surface to the banknote. For the rubbers shown in the drawings, a relatively simple method is to use the resistance rubber quick-change structure. The rear end of the banknote board can be pressed down by hand, and the resistance rubber can be easily removed for replacement.