First turn on the power switch, when you only need to count the number of sheets without authenticating, press the function key to select the "counting" working mode. Then twist a stack of banknotes into a certain slope and place them flat on the slide bank. The machine will automatically complete the counting work. When all the banknotes on the slide bank have been transported, the machine will stop counting. At this time, the number displayed on the display is the number The number of stacks of banknotes, take out the banknotes from the banknote holder, and the automatic control of the value displayed on the display when the banknotes are counted will be reset and counted again.
When counting the banknotes, it is best to separate the banknotes according to different denominations and remove the paper subsidies and pollutants on the banknotes, and then fan the banknotes into a small slope. Slip wheel.
When the banknotes are incorrectly placed, there will be a false positive of the real banknotes or the machine will prompt that the banknotes are not counted correctly. Please reposition the banknotes on the banknote receiver, put them on the banknote input table, and press the reset button to count again. The correct placement of banknotes makes the discrimination ability stronger, and the counting or counting of numbers is more accurate.
When using general money counters, avoid electrical appliances that may cause strong interference to the power grid, such as mobile phones, electric welding machines, etc., and avoid strong direct light and strong magnetic field interference to avoid false authentication failure.
Twisting the banknote wheel, the runner and the resistance rubber should not be contaminated with grease, otherwise it will cause slippage and result in inaccurate counting.
Wait for no less than 5 seconds after the power is cut off and then turn it on again, otherwise it may cause the machine to work abnormally.
The dust on the counter tube and each sensor should be cleaned thoroughly once a week. Just lift the upper cover up and use a brush to clean the dust. Pay attention to turn off the power before cleaning.
When the money feeding is not smooth or the counting is not accurate, you can adjust the gap between the resistance rubber sheet and the money twisting wheel by adjusting the money feeding table screw, and then grab a banknote with your hand and place it between the twisting money and the resistance rubber sheet. Feel the tension. Note: tighten clockwise and relax counter-clockwise.